In Part 5 of our video series titled Essentials of Partial Discharge Testing, Caspar Steineke, partial discharge (PD) expert and co-creator of OMICRON MPD technology, describes how PD data is analyzed and interpreted and explains that expert knowledge is not necessarily required to determine whether detected PD activity is harming the insulation of electrical equipment to cause eventual failure. He describes what level of PD activity is tolerable in various types of electrical equipment and when immediate investigation and remedial action is required to prevent insulation failure and costly outages.
00:00 - Introduction 00:14 - How much experience is required for PD analysis? 00:45 - How do you analyze PD data? 01:46 - What levels of PD are tolerable? 02:37 - Conclusion and contact information
Partial discharge (PD) is a reliable indicator and major cause of deterioration in electrical insulation which can result in equipment failure and costly outages. Regular PD testing is a non-destructive and highly reliable method for assessing the insulation condition of electrical equipment, and it provides users with vital information to plan timely action that ensures their continued reliability and availability.
Hi, my name is Kasper Steinecke. I'm a co-creator of the original MPD technology
and I'm here today to share information on partial discharge testing with you.
When interpreting partial discharge measurements, typically deep experience is not required.
Most measurements are against a certain given threshold and as long as that threshold is not
exceeded, no further action needs to be taken. Consider this a smoke detector test,
as long as the smoke alarm doesn't trigger, all is fine. However, in those rare cases where we
might see unusual patterns or levels in excess of a threshold, we might consider consulting an expert.
When we analyze a PD measurement, we're looking first and foremost at the level of PD according
to IEC 6270, assuming that we have calibrated our measurement accordingly. Now, then we also look
at the PRPD, the phase resolved PD diagram, which gives us a correlation of the PD measurement with
the AC testing voltage. These two measurements taken together provide a lot of information.
PD measuring doesn't have to be hard because a first order measurement can really focus on that
level. We can then record that measurement and pass it on to an expert who can provide further
insight into the pattern. Although simple patterns are easy to understand because they help us to
differentiate between external PD, noise, and internal PD. Internal PD is typically what we're
interested in. Ideally, we want a zero PD environment, but that's not possible, that's not the real world.
So we tolerate some PD on certain assets. We have certain standards to go by. On rotating machines,
we tolerate very considerable levels of PD, but we mostly observe how they change over time.
On transformers, we have power transformers in particular, oil-filled, we have relatively high
levels of PD that are being tolerated. On cables, we want almost no PD and very low levels. So those
measurements are largely concerned with managing external interference in order to look at these
very low potential levels of PD. I hope this information was of interest to you. Omicron has
over 20 years of experience in partial discharge testing and we'd be pleased to work with you in
this area.