BANDGAP REFERENCES || SUPPLY INDEPENDENT BIASING || KTU MSCD || EC462
#ktu #s8ece #mscd
For full class:
https://www.youtube.com/playlist?list=PL2UV2EJdMQmim5UHGAuX6HtsAVCRB-2Ix
Hi all
Today we are starting from 4th module
In 4th module we are going to learn two topics
First one is Bandgap References
and second topic is PLL or Phase Locked Loop
So today we are starting our first topic
Bandgap References
So what are References?
References are
In analog circuits
We have heard about voltage, current, reference voltage, reference current
In analog circuits, we commonly use reference voltage and reference current
All these references are DC quantities
This shows some properties
It depends on the temperature
It depends on the supply and process parameters
It depends on the temperature
It should be a well defined dependence
It depends on the temperature
It depends on the performance
Also, in systems such as A to D and D to A converters
Reference is required to define the input or output full range
Not in A to D or D to A converters
References are used to define the full scale range of A to D or D to A converters
The main objective of a reference is
We have to establish a DC voltage or current
that is independent of supply and process
and has a well defined behavior with temperature
The main objective of a reference is
We have to establish a DC voltage or current
We have to establish a DC voltage or current as a reference
That DC voltage or current should be independent of supply
It should be independent of supply
Also, process parameters and has a well defined behavior with temperature
It should behave properly according to temperature
In most applications, the required temperature dependence assumes one of the three forms
Proportional to absolute temperature
Constant gm behavior
Temperature independent
In most applications, the required temperature dependence assumes one of the three forms
Dependence to supply and process parameters
Today we are discussing about supply independent biasing
What is supply independent biasing?
You can see two circuit diagrams
These two are the circuit diagrams for current mirror biasing
Current mirror biasing was seen in modules 2 & 3
First figure is current mirror biasing
Ideal current switch is used in it
In the second figure, we have used current mirror biasing, but we have used R1 as a resistance.
The first difference is that the eye reference does not vary with VDD.
The channel length modulation of M2 and M3 is neglected.
Then ID2 and ID3 remain independent of supply voltage.
As an approximation of current switch, we tie a resistor from VDD to gate of M1.
The delta Iout here is the change in Iout.
The delta VDD is the change in Iout.
Voltage divided by resistance.
R1 plus 1 by gm1.
Delta VDD divided by R1 plus 1 by gm1.
W by L of 2 divided by W by L of 1.
Output current is quite sensitive to VDD.
The next circuit is the cascading of current mirror circuit.
Figure 2 illustrates an implementation of M3 and M4.
Iout is equal to k times I reference.
Since each diode connected devices feed from a current so is Iout and I reference relatively independent to VDD.
Iout is equal to k times I reference.
RS is used to define Iout and I reference.
VGS1 is the voltage between gate and ground.
VGS1 is equal to VGS2 plus ID2 RS.
VDS1 is independent of VDD.
VTH1 is equal to VTH2.
Thank you for watching. See you in the next class.

