DIY #41 Làm quà sinh nhật Handmade | Khung ảnh trang trí bằng giấy bìa Carton | Dzi Lê Diy

DZI LÊ DIY
51 người theo dõi
2 Lượt xem video·21 thg 9, 2023
DIY#41Làm quà sinh nhật Handmade | Khung ảnh trang trí bằng giấy bìa Carton | Dzi Lê Diy
Nguyên vật liệu:
- Giấy carton
- Giấy Kraft (giấy xi măng)
- Tấm Mica
- Hoa khô, các đồ khô trang trí
- Hình ảnh, hoặc tờ giấy trắng để trang trí.
- Kéo
- Dao rọc giấy
- Bút, thước
- Keo hai mặt
- Súng bắn keo
Hi, welcome back to SillyDIY
In this video, we will make a handmade birthday gift
It is a frame decorated with a piece of paper
This frame is very special because you can decorate it inside
You can also put a picture to wish
or put a sentence that you are very kind to make a gift for someone else
So watch this video to see how I do it
Now I will draw this box first
It is very simple, just like a normal box
Its length is 28cm
Width is 5cm
The total height is 18cm
The length of each bar I will make is 1.5cm
First step, let's make the box
Here I have a lot of cardboard
I will cut it to size 15cm
Cut off both sides because they are not beautiful
I will only take the middle part because it will be more secure
When I do it, the ball keeps coming, it asks for toys all the time
I have to let it go
Then I will measure every 5cm like this
I measure at 2 ends of 5cm and then draw straight lines to cut
Make it even 5cm like this
It keeps coming when I cut the paper
When I hear the sound of cutting, I really like that sound
I sit there and wait for it to come
Because these cardboard pieces are not the same size
The pieces are thick and thin, so I will adjust
I will cut more pieces to get the size of 1.5cm
I will cut another thin piece to get 1.5cm
So I have 2 pieces
I will make 2 more bars with the size of 28x5x1.5cm
So it's 1.5cm
So I have 4 bars like this
Now I will glue these cardboard pieces together
I spread it out like this
And use double-sided glue
Glue on both ends
Because when I glue it like this, I will take the paper and roll it on the outside
So it will ensure that it will not fall out
So I just need to fix it, it doesn't have to stick back and forth
That's it, I will do the same with the other 3
Now I will wear a shirt for this paper frame
I will use craft paper, cement paper
If you like, you can also use other types of paper with patterns and colors
Remember to leave 2 ends for the paper frame
Roll it up
And when you roll it up, remember to put your hand on the 4 edges to create a sharp edge
It will make these edges very beautiful
And use double-sided glue to stick it in
And remember to leave these 2 edges
I will fold it back in a little while
When I put my hand on it, it created the corners
So I will stick it in
I will also use double-sided glue to stick this corner in
I cut off this part a little
At the 2 ends of this frame, you fold it inside in the same direction as this edge
I fold it in like this and use my hand to press it to make it square
Press all 4 edges to make it square
And use double-sided glue to stick it back
Remember to use scissors or something to stick this part
Because it is very hot and easy to be smudged
And finally, I will cut off these corners for it to be really square
I will do the same with the other 2 pieces
And don't forget to follow me on FanpageZilla
So we can share more about DIY, handmade and life
After I finished it, we will have a frame with a very beautiful square corner like this
The next step, we will use double-sided glue to stick these 4 corners back
Note that we will put the connecting materials inside
And the places that are beautiful, smooth, nothing, we will put it outside
And remember to stick it in the corner
And wait for the glue to cool down
Then I will put more glue in the corners to make it more solid
Similarly, I will do the other side
My Zillai DIY is about handmade, home decoration, recycling, gifts and fashion
So if you like these DIY topics, please subscribe and ring the bell to receive my latest videos every week
And I will also be careful to stick all these edges so that it does not fall out
Because it is very solid like this
Now we will make the back of this frame
I will take a piece of cardboard, put the frame on, use a pen around to get a piece of back that is the right size
Now I will use a piece of cement to stick around this piece of paper
Done, I will stick this back to the connecting points
To make the beautiful part, the pearl part, I will turn it out
I will use glue to stick it back
I turn this frame behind my back and put the nose of the glue gun to all the points where there is a gap, then I will stick it back
That's it
And check to see if there is any gap, then I will put the tip of the glue gun in
I rub the glue in and hold it tight
Now we have a frame, yay
Now it's time to cut the mica
I just put half of the mica on the frame, I don't leave the whole frame
Then I use a ruler and a pen to mark the other sides
This place, everyone, remember to be careful
Because the mica is slippery, it takes a while to get this blurry line
And then I will use a knife to cut the mica to cut it
After cutting a lot of lines, we just need to break it
That's it, yay
I really like this knife, everyone, especially the video I directed to make the mica frame
This knife does a very good job
Next, let's make a box to put the picture on
I will put the picture here and decorate the surroundings
However, I have to put the picture a little higher, because if I put it low like this, the decoration around it will cover the whole picture
I will use a cardboard to make a base for this picture
And note that we will make the base smaller than the picture
Because if you make a base that is the same size as the picture, if you put the picture in, you will see the base protruding out, it will not be beautiful
I will cut this part
And use a paper cutter to gently cut these lines
I will break it later, everyone, don't cut too hard, it will fall off
After cutting the middle part, I will cut 2 straight lines
Just cut these 2 small parts
And break it, everyone, can you see it?
If I cut it, I can break it, if I cut too much, it will fall off
Now I continue to cut these 2 lines
And I break 4 corners like this
Turn it upside down and now just stick it in, it's done
Here I will stick it inside
So my base is done
Now I will stick it in the frame
And I stick the picture on, I don't stick a lot of glue, but I stick a little like this, everyone
Done, now I will decorate it
I have dried flowers, dried fruits, dried pine trees
Because I see these things are very colorful and look warm, so I really like this style
And this is a very special thing, it is a corn husk
I kept the corn husk and dried it, now I will cut it out to decorate it here
So these are dried corn husks, everyone
So with these dried flowers or dried things, you can go shopping, find dried flowers, dried pine trees
Or if you are looking for fruits to store oil, we will also sell these
I put the pine tree in, but because it is too high, it will be lifted up when I put the pica up
I can't put the pica in, so I took the pine tree out
If you find this video useful, please click the subscribe button
Click the bell to receive my earliest videos every week
And click the like button
This is the corn husk that I told everyone
Now I will cut it into a leaf shape and decorate it
Now I am studying, but in the future I will use this corn husk to make something very cool
Because it looks like a string
Of course it is much thinner and it is also easy to break
But it's natural, isn't it? Everyone is very beautiful
Now I will fix these decorations with a glue gun
If you like handmade, DIY, recycling, home decor
Don't forget to click the subscribe button of my YouTube channel SillyDIY
Because my channel will make a lot of interesting videos on these topics
When I stick it like this, the glue gun will come out like a spider web
It's white, it's hairy, it just flies around in the place I do it
So later we will have to collect all these glue
The glue that flies like a spider web
We will have to wrap these up cleanly before putting the pica lid on
Because if not, it will look like it has been left for a long time and then the spider web sticks to it
After wrapping, I got a lot like this
I feel that the color of the picture is not very suitable for the overall color
So I wrote a message on this white paper
And I feel that it is much more suitable for this color tone
I will write in the word Live in the moment
And close the frame like this
After closing the frame, I feel that this pen is not impressive enough
And the line is a bit small, so I took a pen with a bigger line
To fill in the upper line and fill in the frame
The lower line is still silent
Actually, the other picture is also damaged, it is also faded
I stick it directly
Stick the pica board on the frame
I only stick 4 corners because this glue gun
If I stick it all, it will be very ugly
So I will stick 4 corners
Thank you so much for taking the time to watch this video with me
Goodbye, see you in the next videos
