【黒松】文人調の黒松を畳み込んでミニ盆栽を作る【盆栽Q】 1

This one, please. This is Kuromatsu. How do you make it? If you're going to make it as it is, it's Bunjincho, right? That's right. Bunjincho is a way of making branches close to the trunk. There are a lot of patterns on this, so I'm going to bring it to the outskirts of the prefecture. Somewhere near the outskirts of the prefecture. There aren't many Bunjincho in Kuromatsu. There aren't many, are there? It's good if it's Akamatsu, but I'm going to lower it. I'm going to change the direction. It's going to be tight, so I'm going to wrap it with tape. There are a lot of leaves, so I'll reduce it a little. How do you reduce it? There are leaves that are yellow near this parting. Last year's leaves were here. This one and this one. Between this leaf and this one. This is last year's leaf. Two years ago. This is last year's leaf. I'm going to take a little bit of this old leaf. I'm going to do this as a whole. I'm pulling it out by hand right now. It's better to cut it with scissors. If you cut it with scissors, there's a groove. There's a groove here. This is the groove. I'm going to leave this and cut it. I'm going to cut it a little higher. If you cut it with scissors. If it's too much trouble, I'll pull it out. When you pull it out, don't pull it out all at once. Take one or two and pull it out. Then the groove will remain. The reason I'm leaving this is because... There's a possibility that the buds will bloom again from here. If this groove remains. I'm going to leave it like that. I'm going to take the leaves. It's best to cut it with scissors. If you pull it out all at once. It's going to hurt the lower branches. The groove will be gone. It's better to pull out the leaves. There are three or four of them. I'm going to pull out a little bit of the branches. Three. Here. There are three of them. I'm going to pull out one of them. I'm going to pull out the lower one. And the car branches here. One, two, three, four. If you put this core in, it'll be five. One, two, three, four, five. It's going to be six. It's like this. I'm going to have to pull this out a little bit. I'm going to pull out a strong branch. It's the head, so I'm going to pull out a strong branch. Two, two. This is the most basic. I'm going to take these three vertical ones. I'm almost done pulling out the branches. That's where the branches are gone. I'm going to lower this a little bit. To bring it closer. It's good to keep it small, isn't it? This pattern is good. I don't want to waste it. I think it's okay to keep it small. I think it's better to tie it up. There's a pattern this close to my feet. I can make it smaller. I'm going to wrap this tape. This tape is not general. It's experimental. Everyone, please use Lafayette. It's usually wrapped in Lafayette. It's elastic, so it won't break even if you bend it. The downside is that it gets wet. It gets wet. In the summer... I did it in the summer, but it's okay now. It's okay now. I thought the tree would shrink. I thought so. It's okay in winter. Are you wrapping it tight? I'm wrapping it tight. I've wrapped it twice. I'm pulling it all the way. It's the same when you wrap the rubber. It's the same when you wrap the tire tube. You have to pull it all the way. Otherwise, it won't work. It's pretty good. I'm sorry to show you this. It's fast. It turns a lot. How do you make it? Let's do this. I'm going to turn it this way. I'm going to stick it in here. I've done the wire harness. I'm going to lower the tree a little more. I don't know if it's going to work with just one wire. I'll try it. Is it easier to bend because it has a pole? It's easier to bend. I'm going to add one more. I'm going to add a little more. I'm going to add about half of it. I'm using a lot of the original pole. I'm just tightening it up a little bit more. It's a little twisted. I'm going to add a little more of this. I'm going to put the head in here. This is the straight line. It's a very different tree. Don't lower the branches. I'm going to raise it all the way up. If you lower it, it's going to be like this. I think it's better to raise it up. It's an interesting shape. If it was loose, I'd crush it like this. The size is small and nice. It's getting smaller. It's got a nice pattern on it. It's kind of three-dimensional. I'm going to lower it a little more. The whole thing is going to change. That's right. If you do too much, the whole thing will be twisted again. That's right. It's a rare shape. There's so much coming from here. There were a lot of fine patterns. This is all I can do. I see. It's a branch. This is interesting. The leaves aren't done well yet. The leaves are facing up. It's different from Goemotsu. The leaves are facing up. If you put a branch on top of this, you can make a Kenzai tree. I think this is good enough. This wire harness. This tree has a lot of patterns on it. You have to make sure the wire comes out. It's coming out of the pole, right? You have to hit it on the back. If it's out of place, you have to hit it when you tighten it. If you don't hit it, it'll break. There's a gap. When you hang the wire, you have to hit it on the back. You have to hit it on the back and bend it from there. If you bend it the other way around, it'll break. It'll break. Originally, the pole was attached. It's hanging on the back of the pole. I see. I'm looking forward to the future. It's good to have a branch like that. It's a black pine tree. If it were a red pine tree, it would be fine. If it were a black pine tree, it would be like this. I did a little. That's right. It's pretty compact. It's new. Is it new? It's new. It's a black pine tree. Black pine trees and messy ones look cool when they turn black. That's right. I thought it would be nice to make it a little fatter. That's right. I made it smaller. It's called a fat pine tree in Bunjincho. I tightened it like this. I think it's okay to make it a little fatter. That's right. About a turn. It's a bee. There are quite a lot of such loose materials. Are there? There are some that are sold. It's difficult to say if there are such fine poles. After all, it's the sole. If there is a proper pole at the bottom, it is the first pole. It depends on how much it is attached to the bottom. It's because you can't make a pole at the bottom later. I can make a small one. There is a big pole over there. There are quite a few patterns. It's attached to a fine pole. The one at the entrance. Let's go. This way? This is the material. Look at this. The sole is attached to the bottom like this. If you cut a long one like this, you can make a small one. When choosing a material, it is the sole. There are quite a few patterns. This person is making a strong pattern to make a small one. It's also good for the edge. On the other hand, this is useless. You have to make use of it. This is attached to the sole. I think the price of this and this is completely different. When you want to make a small one, you can make a small one from this. If the cat comes out, you can make a strong pattern on the sole. You have to make a pattern on the sole. That's all. We will end today while looking at the new material. Thank you very much. Thank you.