Крепление экшн камеры на ружье, SONY HDR-AS300 FDR-X3000 за пол часа :) грубый но быстрый способ

Friends hello It's me again without any previously prepared text I'll just state the fact There is a Sony HDR AS300 camera in the box Here's one such clip All the accessories are for Sony A very expensive pleasure I already ordered it on AliExpress All of this with Navi A GoPro adapter And everything everything everything ordered When will all of this be over I already want to experience it underwater I thought it wouldn't work but I taped the gun with duct tape Let's try something I'll show you He was in the hardware store Bought some Polish corner pieces Tin ones painted One larger the other smaller This is all for testing There was an idea to attach a good harness to the gun I also took two bolts along the thread and took washers The washers are rubber So that everything can be zoomed in on Do not increase The screws will be useful Only these long ones fit the thread They are very long in principle But only these fit the thread They can be cut We're going to do something clever now I' ll show you everything Naturally without her Without white tape I start the test with a smaller corner What did we do We leveled it with a hammer Here is the plane We will cut here now This part will go to the gun I adjusted it a little And like this with the little blue ones Of course a complete mess results But tomorrow I' m going hunting I really want to secure the camera We bend it just a little So that it can embrace the rifle Well colleagues I cut off this chatterbox By the way I want to say something about him right away He's here with the notches The consultant as soon as she saw him What I need is photo and video equipment immediately she went Dolt she says we only have this kind of engraving These are the long ones I cut them Everything is coming together I specifically bought these rubber washers To prevent scratches Where have we ended up Here is my green light With the old Chinese lantern It has been serving for already good ten years The LED by the way has already been replaced We made this structure I really want the tip not to be visible in the frame So I'll try to mount a camera somewhere here That's basically the whole system Our old reliable duct tape It is attached like this The construction is quite rigid But in principle it can be adjusted if desired So what What was my idea What do we do next Here in principle is the box The castle here is a bit shorter The video is stretching Yes here under the hex key All can be tightened A rubber band By the way you can also provide the gasket here I will naturally not move the camera Because yourself understand that it's a collective farm Try to check the camera underwater tomorrow Here it is it took long It's dragging on And somehow we'll be testing all of this tomorrow But now it seems we'll have to cut this tape under the streetlight Attach it like this Let's see what happens tomorrow Basically I'll show it again when the camera is already set up Well it turned out like this Basically I wouldn't say it's entirely bad Everything is reliable Nothing bends A tin can is in principle pretty good What's funny is that the bolt is so trendy that I couldn't find a hex key for it here It had to between 4 and 5 Good thing there was such a star in the set It will fit here In principle to delay Right now all I'm going to do is put the camera in the box I'll try shooting outside Just I can through teasing here show off So that the camera is roughly pointing where the tip is looking That's basically it Tightened By the way I moved the puck from here to here so it wouldn't rub against the box I use the rubber band to lift this puck up so it doesn't rub It seems there's enough thread That's it I'll show you tomorrow