How to Make Soldered Jewelry, Episode #5 - Soldering a Simple Bail to a Metal Stamped Disc

Artistry World
108 followers
37 Video Views·Nov 18, 2022
Hi I'm Lisa Niven-Kelley for beaducation.com and I am Ayesha Formansky with Everthine Jewelry and
we have come together in this introduction to soldering series to teach you all kinds
of soldering stuff and in this particular episode we're going to make a really simple bail.
This is our shortest episode in our series. It's a really fun quick project that's really
going to elevate your piece to the next level. Yeah it makes it look so much better than just
popping a hole and putting a jump ring in there. We're also going to introduce you to props using
little props to assist in the soldering of little components and things. Yes it's fun. Enjoy. Here's
how the layout's going to look to add this jump ring to the back to be a bail. So we've got the
jump ring right here and it's partially resting on the sterling silver circle. This black dot here
is just to mark the middle. It's stamped with a lotus on the back so by putting a dot there we
knew exactly where to lay this jump ring so that it was centered and then here's a t-bar that is
just used as a prop to hold it up because otherwise the jump ring would be tilted down and wouldn't be
flush up against the sterling blank. So now I'm going to actually take the jump ring off so that
I could flux underneath it. Just a little spritz, a little heat. There we go. I'm just going to place
this right back in the same spot making sure that my seam is right there in the middle so that when
I solder it it will solder the seam shut and it will solder this jump ring to the circle.
So I'm going to place my pallion kind of right here kind of leaning right on there and perfect.
It's got to be touching the jump ring so it can put solder that to the circle and we also want
it touching the seam so it'll kind of get sucked up in the seam. Heating, heating, heating. I'm not
putting any heat on the jump ring. I'm putting all the heat on the blank because the jump ring
will just be happily warm enough to take all this without getting it. The big blank will transfer
to the jump ring in there. You see how it flowed a nice bright silver flash. It's got the jump ring
flush to the blank and it also jumped up the seam. I'm going to pick it up and quench it and then
we're going to go and see how it comes right off the t-bar and then we're going to go and pickle it
and we will be right back. I pickled the piece, took it out and patinaed it and I put two jump
rings on the top just because I really like that look but look here's our little bail that we just
made. Doesn't that look sweet? So I've also hung it from my one of my other favorite chains besides
popcorn chain is a ball chain and it doesn't come oxidized like this. I just want to point out I've
dipped it in and out of the Jack's silver blackener and then polished it up. I just really like the way
that it looks. So now you know how to do a simple bail. You could get nuts from here. You could make
the bail bigger, smaller obviously. You could texture the jump ring before soldering it on.
You can try to flatten it a little bit. Maybe either add texture with your chasing hammer
or some stamps. There's all kinds of fun options.
