Tommy's Trade Secrets - How To Render A Blockwork Wall Part 2

Magical Mirrors
232 followers
3 Video Views·Nov 17, 2022
Hi, welcome to Tommy's trade secrets. This short clip
is all about plastering and how to do it right so hopefully you'll find it useful.
Take a look at the step-by-step guide and if you like it
print it, keep it and of course use it. Right I'm gonna start from my bottom
corner and take some long strides up the wall.
Right okay so that's it our first coat's on. Okay so now we've got our first coat on
we're going to want to give it a little flattening with our feather edge.
This is just to make sure we haven't got too many bulges in it
so keep it nice and level. Okay so taking the scratching tool we're going to want
to kit up our next coat. So we're going to go horizontal because if you go
vertically then the cement and the next coat is going to fall straight off.
Right so basically just want to give it, you don't want to go too deep
you just want to make sure the cement's right, thumb dry
and just keep going horizontal. Try not to overlap it too much or dig in too deep.
Right okay so now we've got our scratch coat on we're going to want to let that
dry for at least an hour or two till it's
touch dry for our next coat. So what we'll do now is we'll clean up
all the mess I've made and all the tools. Right okay so we've let it go off for a
couple of hours now and it's solid. Now what we're going to do
with the backing trail is we'll scrape it off
all the excess bobbly bits from when we've done our scratch lines.
So now we're ready for our second and final coat. So same as before we'll start on the
bottom corner working our way up. We'll put it on about 10mm thickness
so this way when we come to use our thread edge we can scrape off the excess and then
float up and we've got ourselves a nice rounded ball.
Also it's not going to do any harm to splash a bit of water on, not too much
just so it doesn't suck up too quick.
Okay so that's our second coat on, just going to let it pick up for a little while
but keep it a close eye on it. So now we've filled in all the hollows
now it's time to float off using our float.
What you want to do you want to work in a figure of eight and a circle.
Try to steer away from going up or horizontal
otherwise this way you're going to end up running it in. So if you have any
mishaps like that you can always just get a bit of cement on
your float and fill it back in.
Okay so now we've given it a good float off it's probably time to
protrude our screws through just about two or three mm and then give it the
final go over. Okay so a good little trick for your
plastering float is to pop a few screws in the end
this way when you're giving it your final float you're going to get a nice
key for your plaster to adhere to. Again just working in the figure of eight
give it a nice key for our plaster to go through and that's it.
Okay so that's it job done. If you followed our step-by-step guide then you should
end up with something that looks like this.
Remember all tools and materials used today can be purchased from
Tradesupermarket.com so stay tuned for more Autonomous Trade Secrets.
I hope you found that useful. Now click below to find all the tools and
materials you need for the job. There are products from loads of
merchants all at the cheapest prices on the web.
Thanks very much for watching Tommy's Trade Secrets.
Oh, would you mind rating this video and spread the word.
