130₺LİK H&M KARE YAKA BLUZU 3₺YE DİKTİM _ Damla Toral Markalara Meydan Okuyor.
Nov 13, 2022
130₺LİK H&M KARE YAKA BLUZU 3₺YE DİKTİM _ Damla Toral Markalara Meydan Okuyor.
Today I will show you how to make the shirt you see here
This collar is very nice I was already thinking of making it
They were asked for a lot and we saw them everywhere this year
I thought it might be a good idea when I saw it for 130 TL at H&M
I felt like it was worth about 3 to 4 lira
I used about 1 meter of fabric My fabric was very torn so I'm not sure exactly
One meter to 1.5 meters is enough
You know I used to buy the meter of shirt fabric for 3 TL
This was already a fabric I had in my hands
But I'm just counting it at 3 TL
I used some rubber and such things besides that I mean it's not really made of anything special
My buttons are from Cling Shop's fabric button set
This column has a very different style I gave some small tips related to them in the video
Be sure to watch until the end
Also I think these kinds of blouses from outside aren't very useful
I made this completely useful
I will explain how it works in the video
I don't think there's any need to prolong it further
If you like my video don't forget to press the like button and subscribe to my channel if you want to see more videos
Take very good care of yourself
I will use about one meter of white fabric for my shirt as I mentioned at the beginning of the video
I use a T-shirt like this as a template
There's no particular reason I use it You can use anything
I place the ruler where I want the cut to start and draw a straight line
I am moving up 20 centimeters and drawing the lower part
If you pay attention the place I drew is a bit lower than the middle of the arm
Then I fold my fabric in four in one direction
And I place this t-shirt on top of it
I fold the places I drew I also fold the sleeve
Basically we're going to cut something so tiny
I'm also giving the half arm cast
As you can see the arm is half We don't have a full arm cast
Then I separate one of the pieces
I'm trimming a bit from each part and cutting it from the fold
Thus my front and back pieces were formed
I also cut a similar piece from burlap
I wanted to make the collar part lined
Because in ready-made clothes white shirts are usually unlined
You need to wear something under your clothes
Because your underwear is too visible
So I think it creates a very ugly picture in both cases
For these reasons and because the fabric is not very absorbent
I wanted a piece that would pull our term honestly the middle part
For that reason I wanted to make a lining from white cotton fabric
Also thanks to this lining I can easily
wear this blouse without wearing underwear
Because the glue is a bit thick
And also thanks to the undercoat how clean a finish I achieved
You will see it in the coming minutes
I am setting aside the spare parts
I am layering and pinning the front and back pieces
The reason I'm pinning the edges is not to sew them
Just let it rest on me as if it were standing upright to adjust the pens
Now it's time to determine the position of my pens
You can normally also wear it on top
of your clothes Rather you can fasten it
Because there's nothing to wear on top right now
I did this to show you more comfortably on my mannequin
I fixed my pieces on my mannequin like this
I then place it in the middle part of the front piece around my waist
Then I just hold it in the shape of an ear and needle the extra part
When it looks right the neck opening gets smaller and then slightly larger already in this area
I adjust them to fit my body properly
I also position the back part so that the lower parts fit around my waist
After making a piece I make the other piece in the same way
For this I use a template
I'm looking at them wondering how far away and how folded I am
Then I place the needles in the same way imitating the other piece
I will sew the straight stitches from the places I showed you with my finger
I follow the same steps for my other pieces
I had somewhat dropped the pin while it was on the mannequin
I'm just doing what
I have to do No matter how carefully I fold it I always end up continuing that habit
Because the image of retirement doesn't make me happy at all I don't like it
That's why I usually try to use all my pension
I ironed my dress carefully after taking it off The direction
of ironing should always be towards the inside of your body
I also apply a layer of paste to my base imitating the things I folded earlier
Then I place the back and front pieces on top of each other with their faces facing each other
And I pin them from under the armpits to the waist
Yes we did it differently this time
My pieces look like this
Now I am putting them aside
I cut two rectangles each as long as the front and about 6-7 cm thick
I also iron half of these pieces
I wanted them to stand a bit more upright in front so I pressed them with an iron
It's not that necessary but it makes things much much better
I double these like this
First we will make a graft with a large amount
For that I set the other one aside
I also use a rubber for the graft
These are known as baby rubber
It is a soft rubber and its appearance is somewhat pleasant
That's why I used it
I place the mesh on the piece and mark the hole positions at equal intervals
I pin my scarf around my rectangle like this
I'm pushing my tire a bit outward from the muddy part
These are actually the real things that will form our identity
You can do this part by part instead of rolling it up
But in my opinion this is the easiest way
I had already seen him somewhere else so I tried that
I will sew along the edges I have pricked with my finger
I sewed it a few times at regular intervals
So that it stays intact and doesn't get damaged
It looks like this after the stitches
Now normally our navel will stick out a little like this
I am doing the exact opposite of this
That is instead of these raised parts facing outward
I am looking inward
And I pin my shirt to her face
There's something important here this rectangle I cut
I'm stitching from the bottom of the entire fabric layer not the edge
Otherwise it wouldn't look so tiny
The entire part is visible
I will put a piece on the other side to sew on a button
I'm taking the piece of fabric I set aside and I'll sew it with a straight stitch top and bottom
I just sewed the top here but later turned it inside out and sewed the bottom as well and then left
I don't know why I did it
But you two should both be upright
I pin this to the other edge of my piece after the dictation
This time I will pin it directly from the edge
Because I want him to go outside
After preparing all of these it was time for the part under the flywheel
I will adjust the flywheel from the remaining part of the piece I cut off the body
I first measured my wings at 20 centimeters and they were 10 centimeters in the middle
I had a 10-centimeter mustache
But later I trimmed it a bit
Then it became a little shorter than 10 centimeters
I'm trying to evaluate the remaining parts as much as possible
I'm cutting a few more pieces of my belt
Because it's wavy the joints don't appear very much
I'm making the most of it right now
Because I didn't have a whole piece so I used a little fabric
I am straightening the ends of the rivet parts and attaching them to each other
Pay attention to the direction of the insertion because it can get a bit confusing
I had four but it was way too much
I didn't even use three of them
I will sew these together with straight stitches at the seams
Also the parts I am showing with this finger
I will curl the entire outer edge including the edges with a curling foot
This is how it looks after stitching
We need to cut the front parts straight
not diagonally as we cut the rim
If you do this you will understand it hasn't sunk in yet
I then place it on my shirt
I think the same way again
If you look down I'm pricking you with the button on my shirt as if looking up
Make sure to pay attention to the
reverse side here I didn't cut
this on purpose Because I keep sewing and checking constantly
I will plant where I am pointing
You can skip this part but I wanted to sew these sections as well before padding for easier sewing
Then I roll the added pieces on these edges and the underlying flange inward
I'm placing it because of the lining I have on top
I sew with a straight stitch from all the places I'm pointing to except for the elbow creases
What's important here is not to miss the edge of the underlay when sewing the front parts of the shirt
Then all of them need to be planted separately
You need to pay a little bit of attention to it
You can prick it from the middle if you like
This is how it looks after stitching
I'm switching from one of my games
I cut well into the corners with scissors
I cleaned all the edges with an overlock to make the corners end neatly
It looks like this after we carefully smoothed it out
Now it's time for the sleeves
I fold my fabric into four again for the sleeves
I am putting the sleeve of the shirt I wore earlier in place of the collar
My shirt sleeve was already three-quarters of a sleeve
That is it was a short sleeve
I made it according to the size
I just made it a little longer
If your sleeves are long you need to shorten them
accordingly You can also mark it by putting it on top of you
If you cut this top part wider and longer it will have more watermelon stems
I cut it off as if it were a normal arm because I didn't want it to look overly exaggerated in that way
You can make a watermelon by playing with the size of these parts
I ironed my pieces after cutting them I
would like to draw your attention to this
I folded it in half so that the inside would be on the outside
And I sewed along the places I had indicated with my fingers
It looks like this after the dictation
I also overlocked this part because I'll need it soon
After the column I am aligning the seam of my arm with the part where the front and back pieces are joined
I'm pinning towards the edges
Normally I start from the top and trim the edges as you know
We are doing the exact opposite this time
I sew from the places I showed with my finger
It looks like this after the dictation
Now I fold the exposed part which is the top of our arm inward by the width of a seam and stitch it
Woven fabrics do not simply rotate in these round sections
It's not a problem at all that part will be gathered you can also pin it by folding it over like that
After sewing through the places I'm pointing at I'll thread a rubber through it
I will pass through the baby tire I used in the past
You get the best results for driving tires on such soft ground by using a tire chain
Because the fork kept opening continuously everywhere
I adjust my suspension to my liking after changing my tire
Make sure to park properly after it's been told to you here
I prick the seam where I joined the ends of my tire with my arm and body
Thus there will be no visible seams from the outside
After preparing the two columns in the same way this is how it looks
I will put rubber tips on the ends of the arms
I am cleaning the end of my arm and then folding it inward a bit
After sewing a straight stitch along the edge I thread a rubber through it
I am sewing my tire after adjusting its length
I am sending it inside and sewing the remaining open part
Now I will make the buttons
I will use this button-making kit I bought from Clean Shop for the buttons
I had already filmed this you can see how it is
You can watch it by going to the link in the top right corner
I made my buttons from my own fabric
You can also use such colorful buttons in a different style
You can also go directly and buy a ready-made button
But the fabric button really looks great on these blouses
Now I insert needles where my joints meet
I mark
these places Because I am going to sew my buttons
After sewing each of my buttons this is how it looks
As you can see it's completely clean inside
The outside is also very beautiful
I really liked it
I hope you liked it too
If you enjoyed the video don't forget to like it and subscribe to my channel if you want to see more videos
Take very good care of yourself

