Disclosure: Please note that some of the links above are affiliate links, and at NO additional cost to you, I will earn a commission if you decide to make a purchase after clicking through the link.
Did you know that you can make your own homemade calligraphy pen out of soda cans? It's easy and
in this video I'll show you how it's done. The materials you're going to need are pencils,
tape, scissors, exacto knife, empty aluminum soda can, some ink, a screw,
and some extra fine sandpaper. You can download this free template by following the link in the
description down below. I'm going to use template number two for this tutorial but the same steps
will apply to all three templates. Begin by cutting out the template and set it aside when done.
Use your exacto knife to make a vertical cut on the soda can. This cut will make an opening that
will fit the scissors. I'll cut around the can one more time to remove the pointy and sharp edges.
Tape the template onto the can. This will hold it in place to make cutting easier. While holding
the template and the aluminum in place, make a soft bend on the dotted line. I use the edge of
my ruler to make a straight bend. Use your screw to make ink holes on the aluminum. You don't have
to make a lot of holes. Three to four will do. Also, don't put them too close. Keep them evenly spaced.
Tape the side that is labeled base to your pencil. Try to tape it as tight as possible.
Pull the side labeled nib to lay parallel to the pencil and tape it in place. Make an inward bend
on the side labeled bend. This will be the ink reservoir and will hold your ink in place.
This last step is very important because the holes made with the screw left the nib too scratchy.
We need it smooth to work properly. I'm going to use this extra fine sandpaper to smooth out the
I'm also going to sand down any pointy or sharp parts left around the aluminum. Do not sand too
hard. If you do, the aluminum will break and you'll have to start over. Test out your new nib. If done
correctly, the result is a completely functional pen that you can use for calligraphy. I wanted to
try to give the lines a bit of style so I made a different nib where I cut out a small portion of
the aluminum marked here as a black rectangle. I created the ink holes and then cut the small
piece off. When I made this cut, it distorted the nib a bit but I managed to return it back to normal
and this is the result. It can be a bit difficult to get proper ink flow with this pen but still fun
to use. If you have any questions, feel free to leave a comment down below. I'll see you in the
next video. Thank you for watching.