Aesthetic DIY Gift Ideas 🍑 Cottagecore / Fairycore inspired 🍑 Cute Room Decor Ideas

Art Bond
128 followers
3 Video Views·Oct 30, 2022
Hello everyone and welcome back to another DIY gift idea video.
In this video I'm going to be showing you three DIY gift ideas each with a fairy or cottagecore
or woodland theme. For this craft I started with two pieces of fabric both around 8 by 10 inches
with a seam allowance going all the way around. Marking where I wanted the fold of the case to be
I sewed a basting stitch on both fabrics. This will work as a guide whilst embroidering and
sewing on the pockets. I drew an outline for my embroidery on what will be the front of the case
and well embroidered it. For the design I just copied out a picture that I saw online
but added some more flowers to make it look a bit more summery.
After two days of embroidering I realized that I was sewing on the wrong side of the fabric
so now it doesn't open. It opens in the opposite direction which isn't too important but
I think next time I'm definitely going to have to pay attention to what side of the fabric
I'm actually sewing on. Next I measured out the size I wanted my pockets to be
so I ended up making them about 5 by 10 inches remembering to add a seam allowance all the way
around. I folded and pinned the top of the pocket to hide the raw edge and then pinned
lace going all the way along the top just to look a bit more decorative.
I did try to machine sew the lace onto the pocket but because the lace was a bit stretchy
it didn't work out very well so I just ended up hand sewing it. Then I sewed the pocket to
the lining fabric making sure that the good side of both fabrics were facing up.
I machine sewed a few storage channels and also hand sewed a little extra pocket.
Then I pinned the two fabrics together good side to good side encasing a piece of string
in between the two fabrics near the front edge. This will be used as the closure later on.
Then I just sewed along the edge making sure to leave a gap so that I may turn the case inside
out. Once turned inside out I folded the edge of the gap inward and then sewed as close to the
edge as I could all the way around the case. Finally all that's left to do is to sew a piece
of string to the back of the pencil case, remove the basting stitches and it's finished.
For this next project I just used a plastic bowl, some jute string, some pva glue otherwise known as
school glue or modge podge and a paintbrush and I just simply glued and wrapped the string around
the plastic bowl. This could be a bit fiddly especially at the beginning and the end so I
just took my time and made sure to use plenty of glue. When I got to the end the tail of the
string wouldn't stick down very well so I just used some super glue and held it down for a little while
just to make sure it stayed in place. Then I just covered the bowl with a layer of pva glue.
So when that was dry I simply just removed the string bowl from the plastic bowl
and then I covered the inside with a layer of pva glue once again just to make sure everything
stayed in place and whilst I waited for that to dry I went foraging for some foliage to decorate it.
When I got home I washed the leaves and the flowers to get rid of any germs and then I left
them in the window for a day or two to fully dry. I also sprinkled a bit of baking powder over the
leaves to make them dry faster. Some dry glue was hanging around the edge of the bowl so I just made
sure to cut that off and then when the foliage was fully dried I glued them around the bowl
and finally when that was dry I went over everything with another layer of pva glue
just to make sure everything stayed in place and to preserve the flowers and the leaves.
And for the last project all that's required is a frame and some of the leftover foliage.
Because the photo frame I used was a bit too smooth I used sandpaper to roughen it up a bit
so that the foliage would actually have something to stick to. Then I just proceeded to glue the
flowers and leaves to the frame and once again I covered everything in a layer of pva glue
to keep everything preserved and in place and that's it that's the gift done. And that's all
for this video if you liked it please give it a thumbs up and subscribe and I hope you found
some of these gift ideas useful and I'll see you next time, bye!
