Surfboard Ding Repair and Color Match [EPS Foam + Epoxy Resin]
123 Steps
106 followers
2 Video Views·Oct 23, 2022
All right, check this out. I was driving to the beach and forgot to secure my truck bed cover.
It flipped over and boom right into the board. Put a big ding right in the middle. I even had
my board bag on which I just took off and it went straight through that as well. Time for a ding repair.
All right, so I filled the ding and cleaned up the area. This board has a strip of carbon fiber
tape going down the middle of it and then it has this vector tape back here.
I don't have carbon fiber tape or vector tape and unfortunately this ding is right on the edge
of the carbon fiber strip and right on the edge of the vector tape as well and it would be really
hard to try and put carbon fiber right down the middle of it. So rather than even trying to deal
with that, I'm just using patches of fiberglass. I have two six ounce patches and one four ounce
patch that I'm just going to layer and it should give it plenty of strength and then we'll just go
from there.
All right, so trying to blend it back to the color of the board is going to be a little
bit difficult. This is a salmon color so I have some acrylic paints here, a pink and a red one
that I think I can mix together to bring it as close to that original color as I can
and then I have a black paint pen that I'll use to match the color of the carbon tape. It's not
going to be perfect but it'll look better than the white patch that it is right now and that's
good enough for me.
