N-23 特色花柱示範 Floral Pillar using Suspension and Spiralling skill

Soak the mud in water and place it in this position When placing it do not use your fingers use your palm Press it down in the center We can choose some leaves Place them on the mud Place some larger longer ones on top We will cut these delphiniums into about four-inch stems We'll use the same method as before Place a flower next to each leaf and each bellflower You can do the same This one can be placed a bit higher This position is a bit higher This one is the same You can place one in the top middle and bottom first We can cover the column next You can use some large Nestlé palms You can trim the base Cut a little into the soil These positions we can add a piece here at the back add a leaf or even you can add another piece next to it these positions you can place it diagonally on purpose no need to be too straight You can tilt it slightly at these positions to make it look good with a little overlap and texture No need Next is the most important part of today because we are going to make a spiral So we use the spring orchid leaf then when we come in we have to come in like this a little bit curved is okay a little bit slanted then here you can do it like this slowly put it in Put it approximately in the middle We have already put all the Platycodon and Spring Orchid leaves in Next we will put some flowers here Today we are going to say This mud is more suitable for large areas We will lay a little sabah leaf then we will put a pole like these fences as for these fences like these it is a bit softer we can place it like this you can place it diagonally Let it fall like that Let it fall diagonally If it is soft Let it fall like that If it is hard You can let it fall straight Then we can add another one as well Another one can be added as well Not too long These lengths We will take another white fence post You can shorten it slightly Slightly We can all add another one on top These positions Add another one on top Do not fly out focus mainly in front add a little more flowers here for example like these green lies these positions we can add a little add a few branches not too long Like these positions short can add a few then we need to add a little leaves now like these add a little leaves thesesame mung bean sprouts as for the top we need to add a little flowers We can add some red ribbons these red ribbons you can cut it about six inches six inches up to seven inches we can place them between the branches these positions we can add a little red ribbon These positions these positions next to them can be slightly thrown out as well Here we can also add some orchids Like these they are so long These orchids we can add a little bit here In these spots you can add one or two stems One or two stems Longly in these positions space these positions can add one or two branches these positions You can add a little bit more there you don't have to worry about it being too tight these spaces a little bit more inside try to keep it all inside don't let it go outside you can add a little bit more at the end these positions add a little bit more at the end Look here one more time to see if there's space to add some leaves if there's any mud you haven't covered it yet you can add a little more leaves Sabah can also be added these bean sprouts can also be added add a little more if everyone has time you can also use this method Vertical insertion method Add this Spiral technique To create This floral design